Parrot AR Drone Battery Fix (no external tools required)



Follow me on Twitter!:
Check out the VR company I’m building!:
TL;DW: Just take the battery off the charger and put it back on every time the light flashes red, until the wall adapter pumps enough juice into the battery to jump-start it (as shown in 0:35). From then on, the wall adapter will allow the battery to be fully charged.

30 Replies to “Parrot AR Drone Battery Fix (no external tools required)”

  1. Christopher

    Hadn’t used my drone for 2 years and I tried to start it back up again but was getting the flashing light issue. After around 15 tries using your method I got it working again!!! Thanks.

  2. Uys Fick

    As some people mentioned in earlier posts, my red light did not come on at all. After three years in storage, the battery was completely drained and the charger did not recognize it. I used a 12V car battery, connected the negative to the black wire and touched the positive to the red wire a few times, just to kick some life into it. Now in the charger and the red light is on and stable.

  3. kennsonn

    Thank you very much for the info! I had 2 "dead" batteries but were able to revive them both. The 1st took 32 cycles and the 2nd took 14. Both charged to 100% and work fine! Much appreciated!

  4. Kel Guy

    Don’t Know If agouti Still Monitor This Video- ????Yes – Yours Was The First Vide I UTubed – And It TOOK a Ton Of “ Trickle … ? Just Sat there With AnEXTENTION Cord – Unplugging & Plugging WHILST we Watch(ed the NIGHTLY “ FAKE” NEWS … OVER 60 Times I’m Sure Till The FLASHING STOPPED – Then 90 Minutes To FULL CHARGE TY MY FRIEND !

Leave a Reply

Your email address will not be published. Required fields are marked *