Configure Z-Wave Switch for OpenHAB 1.8 using IMA Tools and OpenHAB Designer



Quick overview of adding a GE 12722 Z-Wave switch to my OpenHAB 1.8 controller.

5 Replies to “Configure Z-Wave Switch for OpenHAB 1.8 using IMA Tools and OpenHAB Designer”

  1. Fandy Dharmawan

    Hi im new to openhab i just got it installed on my raspberry pi, but i havent purchased any hardware yet, which im thinking to get zwave switches my question is do i need to get z wave receiver dongle for my raspberry pi like wat u did on the computer? In order openhab be able to receive zwave hardware?

Leave a Reply

Your email address will not be published. Required fields are marked *